Perimeter of Swimming Pool, Walkway

[Guest]

A rectangular swimming pool has the following description:

Length: 48 ft.
Width - 22 ft.
Bordered by 8.5 ft. walkway.

Determine 1) perimeter around pool, 2) perimeter around outside edge of walkway.

Check my calculations:

Perimeter = 2L + 2W
P = 2(48) + 2(22)
P = 96 + 44
P = 140 ft. around pool.

P = 2(48) + 2(13.5) : Difference between width of pool and walkway.

P = 96 + 27
P = 123 ft. around outside edge of walkway.

[Guest]

The width of the bigger rectangle is 22+2*8.5 = 39
The length is 48+2*8.5 = 65.
The peremeter is 65*2 + 39*2= 130 + 78 = 208

[Guest]

Thanks again.

[Guest]

the perimeter of the rectangular swimming pool is 70 meters .The pool is twice as it is wide .what's the length of the swimming pool. the fringe of the square swimming pool is 70 meters .The pool is twice as it's far huge .what's the duration of the swimming pool

[thoughty1955]

rectangular photos interior a Circle, 24' round Swimming Pool.
24' x 24' = 576'
576' x .7854 = 452.39 squarefeet (general interior pool)

A border of uniform width is located. A border of uniform width is positioned around a rectangular photograph that measures eight inches by 10 inches. If the region of the border is 144 rectangular inches, what's the width of the border, in inches.

[witela10]

Its some extreme for me to see yet its beginning and end is clear after read the border border of swimming pool which is extraordinary clarification by you.
thanks a lot for that.

[cious1934]

The edge is anything but difficult to gauge with a customary measuring tape. With a square or rectangular pool, you can, obviously, measure every one of the four sides and add the estimations together to decide the entire edge, however what is extremely vital is to gauge just a single side of square pool, at that point duplicate by 4.

[Guest]

Thanks.

[prady1943]

Its some outrageous for me to see yet its start and end is clear after perused the fringe outskirt of swimming pool which is exceptional elucidation by you.
The edge is definitely not hard to check with a standard estimating tape.
much appreciated for that.[tex]\rightarrow[/tex]